FILMENTUM MAGIGOO for PC adhesive sticks for better grip on polycarbonate 50ml

Magigoo is an easy -to -use liquid "adhesive" designed to solve your problem with the adhesion of the first layer, a basic problem in 3D printing of FDM technologies. In case of poor adhesion, the printing is separated from the print platform itself. Good adhesion of the first layer is important, as this layer forms the basis for the rest of the press. Magigoo was specially designed for universal use. So it works equally well for PLA, as well as ABS and other filaments.

Magigoo is easy to clean with water - which is the most common and affordable solvent. After each printing it can be cleaned with a damp cloth to prevent excess accumulation of Magigoo.

Adhesive properties of Magigoo are designed to hold the model during printing and release it after cooling. During the cooling process, you will hear a distinctive rupture sound for both ABS and PLA. This will reach the printing of the print from the pad and after completely cooling 3D prints can be easily removed without the use of tools and excessive force.

Magigoo helps fight deformations - which is also a often recurring problem with ABS and ASA material. You will appreciate this advantage, especially during a multi -hour print. In this case, it really depends very much that there is no deformation and problems with adhesion and your long printing is fine.

will last more than 100 uses. It is soluble in water and is therefore easy to clean.

1. Removing the sealing foil
Before use, it is necessary to remove the wheel from the seal that prevents drying and spilling during transport. Unscrew the applicator cover and remove the sealing foil.
2. Apply the product
to the print pad a continuous thin film to ensure the adhesion of the print to the mat. Once the product is applied, the bottle is recommended that the inner liquid does not dry, which could cause clogging the applicator.
3. Printing of the model
Magigoo can be used for 3D printers with heated and unheated printing pad.
4. Removing the model from the pad
When printing, the connection between the materials is very strong as soon as the room temperature is cooling, the printing can be removed without the use of violence.
5. Cleaning the pad
If the rest of the product is unevenly distributed by printing, it is advisable to wipe the pad at the point of use with a damp cloth. For further printing, you can apply a new layer and allow it to dry.