Use :
If the nozzle is clogged, use the drill so that you will gently and slowly in the clockwise. Do not try to push the drill straight into the nozzle, it could break it!
Warning:
When cleaning the nozzle, be sure to preheat it at min 200 ° C.
Note:
The color on the handle may actually differ from the color given on the sprays. However, this does not affect the quality or use of the product.
0,67 €
The set contains 10 pieces of drills with a diameter of 0.2 mm or 0.4 mm used to clean the nozzles. When blocking the nozzle, heat it to about 200 ° C and then clean the clockwise with a gentle circular movements with a drill.
In stock <10pcs
8,05 €
Brass brush for cleaning and removing peeling dirt from print strings from nozzles, hotends, heated cubes, pads, etc.
In stock >10pcs (74 pcs)
2,78 €
Round brush with brass fibers with a 3 mm shaft for clamping in a dremmel or drill. With the brush, you can easily remove dirt from your nozzle and other parts of your 3D printer.
In stock >10pcs (85 pcs)
1,02 €
Needle to clean nozzles 0.2 mm and larger.
In stock >10pcs
0,53 €
